Assembly
Welding table kit assembly guide
Our kits are designed to weld up on a flat floor or flat bench with MIG or TIG. You need a welder, clamps, a square, a grinder and a flat reference surface.
Before you start
- Lay out the parts and match the etched marks.
- Clean mill scale and oil off the weld areas. Parts are HRPO but oiled.
- Work on the top plate face-down on a flat surface.
Build order
- Fit the egg-crate ribs together: long ribs drop into the slots of the cross ribs.
- Fit the perimeter panels to the ribs.
- Lay the top face-down and set the rib assembly into the tab slots.
- Clamp everything square and tack in a balanced pattern to limit distortion.
- Weld the tabs in the top plate slots in stages, moving around the table. Let it cool between passes.
- Weld rib-to-rib seams.
- Grind the weld at the top surface flush, only if you have welded through the slots.
Legs
Weld the 4"x4" top plate to each tube along the etched 2" square, then bolt each top plate to the corner blocks under the table. Weld the foot plate to the bottom of the tube along its etched outline: a flat plate takes a levelling bolt through the 5/8" hole, and a caster plate bolts to a 6" locking caster.
Flatness
Plate flatness comes from the laser cut parts and your tack sequence. Tack, check with a straightedge, and stitch weld to control heat.